APRS Track Direct

My position About ☰

reset

SQ8PDY-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ8PDY-3. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1780612234	266 Count	436 Count	69 Count
1780609531	218 Count	383 Count	56 Count
1780607730	190 Count	326 Count	44 Count
1780606829	169 Count	301 Count	34 Count
1780605919	152 Count	278 Count	31 Count
1780596901	21 Count	45 Count	3 Count
1780594179	502 Count	951 Count	107 Count
1780590591	447 Count	807 Count	97 Count
1780587889	403 Count	710 Count	84 Count
1780586088	381 Count	644 Count	78 Count
1780585186	370 Count	618 Count	78 Count
1780582485	324 Count	546 Count	69 Count
1780581585	312 Count	526 Count	68 Count
1780577981	255 Count	447 Count	59 Count
1780577080	243 Count	423 Count	56 Count
1780576180	227 Count	405 Count	53 Count
1780575279	209 Count	382 Count	47 Count
1780574379	194 Count	353 Count	46 Count
1780573478	171 Count	328 Count	39 Count
1780572578	161 Count	294 Count	36 Count
1780568088	95 Count	169 Count	24 Count
1780567188	83 Count	152 Count	23 Count
1780566287	64 Count	114 Count	13 Count
1780564486	36 Count	70 Count	7 Count
1780560883	321 Count	993 Count	177 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)