APRS Track Direct

My position About ☰

reset

W4KEL-7 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object W4KEL-7. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*
1791129472	13.62	24.16
1791127429	13.57	23.67
1791125387	13.51	23.18
1791123345	13.51	22.7
1791121303	13.45	22.7
1791119261	13.45	22.21
1791117219	13.42	22.21
1791115177	13.42	22.21
1791113135	13.42	22.21
1791111093	13.42	21.72
1791109050	13.42	22.21
1791107008	13.42	22.21
1791104966	13.45	21.72
1791102924	13.42	21.72
1791100882	13.42	21.72
1791098840	13.42	21.72
1791096798	13.42	21.72
1791094756	13.42	21.72
1791092714	13.42	21.72
1791090672	13.42	21.72
1791088631	13.45	21.72
1791086589	13.42	21.72
1791084547	13.42	21.72
1791082505	13.42	21.72
1791080463	13.39	21.72

*Used Equation Coefficients:

Value1: 0, 0.0293, 0

Value2: 0, 0.489, -273.15

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)