APRS Track Direct

My position About ☰

reset

SP2PA-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2PA-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1765030883	24 Count	32 Count	6 Count
1765029082	23 Count	32 Count	6 Count
1765027281	22 Count	32 Count	6 Count
1765025480	19 Count	29 Count	4 Count
1765023679	17 Count	27 Count	3 Count
1765021878	15 Count	26 Count	2 Count
1765020089	13 Count	24 Count	1 Count
1765018288	12 Count	24 Count	1 Count
1765016487	10 Count	20 Count	0 Count
1765014686	9 Count	18 Count	0 Count
1765012885	8 Count	16 Count	0 Count
1765011084	7 Count	15 Count	0 Count
1765009283	6 Count	13 Count	0 Count
1765007482	5 Count	12 Count	0 Count
1765005681	4 Count	10 Count	0 Count
1765003880	3 Count	8 Count	0 Count
1765002079	2 Count	6 Count	0 Count
1765000278	1 Count	4 Count	0 Count
1764998488	0 Count	2 Count	0 Count
1764996687	588 Count	1003 Count	177 Count
1764994886	587 Count	996 Count	177 Count
1764993085	586 Count	994 Count	177 Count
1764991284	585 Count	992 Count	177 Count
1764989483	584 Count	990 Count	177 Count
1764987682	583 Count	988 Count	177 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)