APRS Track Direct

My position About ☰

reset

DG4CB-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object DG4CB-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1769635426	579 Count	993 Count
1769631819	577 Count	991 Count
1769630016	576 Count	990 Count
1769628213	575 Count	989 Count
1769626409	574 Count	988 Count
1769624606	573 Count	987 Count
1769622803	572 Count	986 Count
1769621000	571 Count	985 Count
1769619196	570 Count	984 Count
1769617393	569 Count	983 Count
1769613861	563 Count	980 Count
1769612057	562 Count	979 Count
1769610254	561 Count	978 Count
1769608450	560 Count	977 Count
1769606647	559 Count	977 Count
1769604844	558 Count	976 Count
1769603042	557 Count	975 Count
1769601238	556 Count	974 Count
1769597633	554 Count	972 Count
1769595830	553 Count	971 Count
1769594027	552 Count	970 Count
1769592224	551 Count	969 Count
1769590421	550 Count	965 Count
1769588618	549 Count	964 Count
1769586815	548 Count	963 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)