APRS Track Direct

My position About ☰

reset

IU3ISP-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IU3ISP-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1775204634	224 Count	762 Count	166 Count
1775202874	217 Count	713 Count	164 Count
1775201070	211 Count	669 Count	159 Count
1775195658	191 Count	563 Count	142 Count
1775193854	188 Count	561 Count	140 Count
1775192050	183 Count	557 Count	136 Count
1775190247	181 Count	556 Count	135 Count
1775188443	176 Count	552 Count	131 Count
1775186639	172 Count	549 Count	128 Count
1775183031	164 Count	543 Count	122 Count
1775181271	156 Count	540 Count	119 Count
1775179467	151 Count	536 Count	115 Count
1775177663	147 Count	533 Count	112 Count
1775175859	142 Count	529 Count	108 Count
1775174055	138 Count	526 Count	105 Count
1775170449	129 Count	512 Count	98 Count
1775166840	117 Count	444 Count	88 Count
1775163232	104 Count	374 Count	77 Count
1775161428	99 Count	365 Count	73 Count
1775159668	91 Count	362 Count	70 Count
1775157864	87 Count	359 Count	67 Count
1775156060	82 Count	355 Count	63 Count
1775154257	80 Count	354 Count	62 Count
1775150649	71 Count	315 Count	55 Count
1775148845	64 Count	283 Count	49 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)