APRS Track Direct

My position About ☰

reset

SP3KON-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP3KON-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1769644959	202 Count	592 Count	71 Count
1769644058	189 Count	568 Count	68 Count
1769643158	183 Count	549 Count	65 Count
1769642257	177 Count	533 Count	62 Count
1769641356	164 Count	518 Count	59 Count
1769640455	157 Count	500 Count	56 Count
1769639576	141 Count	485 Count	53 Count
1769638675	135 Count	471 Count	51 Count
1769637774	130 Count	459 Count	50 Count
1769636873	119 Count	444 Count	48 Count
1769635973	115 Count	432 Count	47 Count
1769635071	107 Count	417 Count	45 Count
1769634171	64 Count	391 Count	44 Count
1769633270	60 Count	377 Count	41 Count
1769632369	58 Count	368 Count	40 Count
1769631468	55 Count	355 Count	38 Count
1769630567	53 Count	347 Count	37 Count
1769629665	50 Count	334 Count	35 Count
1769628764	39 Count	291 Count	25 Count
1769627863	37 Count	263 Count	24 Count
1769626962	35 Count	236 Count	23 Count
1769626062	29 Count	200 Count	18 Count
1769625161	27 Count	191 Count	17 Count
1769624260	24 Count	175 Count	15 Count
1769623359	22 Count	166 Count	14 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)