APRS Track Direct

My position About ☰

reset

F6JON-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F6JON-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1775212048	186 Count	349 Count	108 Count
1775211445	180 Count	344 Count	103 Count
1775210842	172 Count	335 Count	96 Count
1775210239	154 Count	307 Count	91 Count
1775209636	147 Count	301 Count	85 Count
1775209032	141 Count	294 Count	80 Count
1775208429	135 Count	286 Count	75 Count
1775207821	126 Count	270 Count	70 Count
1775207218	104 Count	227 Count	62 Count
1775206615	87 Count	185 Count	52 Count
1775206007	73 Count	158 Count	45 Count
1775205398	62 Count	127 Count	35 Count
1775204921	55 Count	115 Count	32 Count
1775204318	50 Count	100 Count	28 Count
1775203715	42 Count	87 Count	23 Count
1775203112	36 Count	79 Count	18 Count
1775202504	20 Count	49 Count	13 Count
1775201901	14 Count	19 Count	10 Count
1775201298	8 Count	7 Count	6 Count
1775200695	810 Count	1006 Count	588 Count
1775200091	804 Count	999 Count	583 Count
1775199488	797 Count	989 Count	577 Count
1775198885	787 Count	972 Count	572 Count
1775198282	783 Count	965 Count	569 Count
1775197679	777 Count	958 Count	564 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)