APRS Track Direct

My position About ☰

reset

SQ2PDS-6 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ2PDS-6. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1791442703	133 Count	951 Count	84 Count
1791441919	123 Count	946 Count	84 Count
1791440558	120 Count	926 Count	82 Count
1791438757	117 Count	888 Count	80 Count
1791436956	114 Count	845 Count	78 Count
1791435156	111 Count	801 Count	76 Count
1791433355	108 Count	769 Count	74 Count
1791431554	105 Count	743 Count	72 Count
1791429754	102 Count	713 Count	70 Count
1791427960	94 Count	684 Count	63 Count
1791426159	91 Count	651 Count	61 Count
1791424359	87 Count	626 Count	58 Count
1791422558	84 Count	605 Count	56 Count
1791420757	80 Count	577 Count	53 Count
1791418956	77 Count	551 Count	51 Count
1791417156	73 Count	524 Count	48 Count
1791415355	70 Count	497 Count	46 Count
1791413554	67 Count	466 Count	44 Count
1791411753	64 Count	440 Count	42 Count
1791409953	60 Count	400 Count	39 Count
1791408152	57 Count	352 Count	37 Count
1791406356	49 Count	315 Count	30 Count
1791404556	46 Count	278 Count	28 Count
1791402755	42 Count	250 Count	25 Count
1791400954	39 Count	225 Count	23 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)