APRS Track Direct

My position About ☰

reset

SR8MBR-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR8MBR-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1791105603	469 Count	488 Count
1791103802	437 Count	467 Count
1791102002	382 Count	407 Count
1791100208	324 Count	357 Count
1791098407	259 Count	301 Count
1791096607	209 Count	245 Count
1791094806	177 Count	213 Count
1791093005	134 Count	160 Count
1791091205	98 Count	119 Count
1791089404	62 Count	80 Count
1791087603	35 Count	43 Count
1791085803	952 Count	1022 Count
1791084002	923 Count	995 Count
1791082201	891 Count	957 Count
1791080401	862 Count	921 Count
1791078608	825 Count	891 Count
1791076808	795 Count	860 Count
1791075007	764 Count	832 Count
1791073206	725 Count	790 Count
1791071406	690 Count	753 Count
1791067804	627 Count	690 Count
1791066004	593 Count	658 Count
1791064203	561 Count	617 Count
1791062401	523 Count	583 Count
1791060601	493 Count	553 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)