APRS Track Direct

My position About ☰

reset

OK1FWG-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OK1FWG-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1791188006	709 Count	327 Count	110 Count
1791186202	706 Count	327 Count	110 Count
1791184399	705 Count	327 Count	110 Count
1791182596	697 Count	321 Count	104 Count
1791178990	692 Count	309 Count	104 Count
1791177187	690 Count	309 Count	104 Count
1791175384	689 Count	309 Count	104 Count
1791173581	688 Count	309 Count	104 Count
1791171778	684 Count	309 Count	104 Count
1791169974	683 Count	309 Count	104 Count
1791168171	681 Count	309 Count	104 Count
1791166368	680 Count	309 Count	104 Count
1791164565	677 Count	309 Count	104 Count
1791162762	676 Count	309 Count	104 Count
1791160959	674 Count	309 Count	104 Count
1791159156	673 Count	309 Count	104 Count
1791157353	670 Count	309 Count	104 Count
1791155550	668 Count	309 Count	104 Count
1791153747	667 Count	309 Count	104 Count
1791151943	666 Count	309 Count	104 Count
1791150140	662 Count	309 Count	104 Count
1791148337	661 Count	309 Count	104 Count
1791146534	660 Count	296 Count	104 Count
1791144731	658 Count	292 Count	104 Count
1791142928	655 Count	292 Count	104 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)