APRS Track Direct

My position About ☰

reset

SP2SGK-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2SGK-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1765029392	731 Count	578 Count	366 Count
1765028489	729 Count	577 Count	365 Count
1765027586	727 Count	576 Count	364 Count
1765026683	725 Count	575 Count	363 Count
1765025779	723 Count	574 Count	362 Count
1765024877	721 Count	573 Count	361 Count
1765023974	719 Count	572 Count	360 Count
1765023071	717 Count	571 Count	359 Count
1765022168	715 Count	570 Count	358 Count
1765021265	713 Count	569 Count	357 Count
1765020362	711 Count	568 Count	356 Count
1765019459	709 Count	567 Count	355 Count
1765018556	707 Count	566 Count	354 Count
1765017653	705 Count	565 Count	353 Count
1765016750	703 Count	564 Count	352 Count
1765015919	701 Count	563 Count	351 Count
1765015016	699 Count	562 Count	350 Count
1765013210	695 Count	560 Count	348 Count
1765012307	693 Count	559 Count	347 Count
1765011403	691 Count	558 Count	346 Count
1765010500	689 Count	557 Count	345 Count
1765009597	687 Count	556 Count	344 Count
1765008694	685 Count	555 Count	343 Count
1765007791	683 Count	554 Count	342 Count
1765006888	681 Count	553 Count	341 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)