APRS Track Direct

My position About ☰

reset

SP2OSA Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2OSA. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1780610494	125 Count	471 Count	21 Count
1780608693	124 Count	467 Count	21 Count
1780606893	123 Count	463 Count	21 Count
1780603291	121 Count	456 Count	21 Count
1780601490	120 Count	453 Count	21 Count
1780599690	119 Count	451 Count	21 Count
1780597889	118 Count	448 Count	21 Count
1780594288	113 Count	440 Count	18 Count
1780592487	112 Count	438 Count	18 Count
1780590686	111 Count	434 Count	18 Count
1780588663	106 Count	430 Count	18 Count
1780586862	105 Count	406 Count	18 Count
1780585061	104 Count	377 Count	18 Count
1780583261	103 Count	373 Count	18 Count
1780581460	102 Count	369 Count	18 Count
1780579659	101 Count	365 Count	18 Count
1780577859	100 Count	361 Count	18 Count
1780576058	99 Count	357 Count	18 Count
1780574257	98 Count	353 Count	18 Count
1780572456	94 Count	345 Count	15 Count
1780570656	93 Count	341 Count	15 Count
1780568855	92 Count	332 Count	15 Count
1780552652	87 Count	328 Count	15 Count
1780550852	83 Count	321 Count	12 Count
1780549051	82 Count	317 Count	12 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)