APRS Track Direct

My position About ☰

reset

OK4RS-12 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OK4RS-12. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1765018671	609 Count	14 Count	13 Count
1765016879	608 Count	14 Count	13 Count
1765015078	607 Count	14 Count	13 Count
1765013277	606 Count	14 Count	13 Count
1765011476	605 Count	14 Count	13 Count
1765009676	604 Count	14 Count	13 Count
1765007875	603 Count	14 Count	13 Count
1765006074	602 Count	14 Count	13 Count
1765004273	601 Count	14 Count	13 Count
1765002473	600 Count	14 Count	13 Count
1765000672	599 Count	14 Count	13 Count
1764998871	598 Count	14 Count	13 Count
1764997070	597 Count	14 Count	13 Count
1764995278	596 Count	14 Count	13 Count
1764993477	595 Count	14 Count	13 Count
1764991677	594 Count	14 Count	13 Count
1764989876	593 Count	14 Count	13 Count
1764988075	592 Count	14 Count	13 Count
1764986274	591 Count	14 Count	13 Count
1764984473	590 Count	14 Count	13 Count
1764982673	589 Count	14 Count	13 Count
1764980872	588 Count	14 Count	13 Count
1764979071	587 Count	14 Count	13 Count
1764977270	586 Count	14 Count	13 Count
1764975469	585 Count	14 Count	13 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)