APRS Track Direct

My position About ☰

reset

SQ9KFP-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9KFP-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1780605576	3 Count	31 Count
1780603775	1 Count	19 Count
1780602875	0 Count	8 Count
1780601974	115 Count	1004 Count
1780601074	114 Count	988 Count
1780600173	113 Count	967 Count
1780599272	112 Count	954 Count
1780597471	110 Count	932 Count
1780596571	109 Count	923 Count
1780594770	107 Count	902 Count
1780593869	106 Count	895 Count
1780592968	105 Count	886 Count
1780592068	104 Count	878 Count
1780591336	99 Count	878 Count
1780590436	98 Count	867 Count
1780589535	97 Count	860 Count
1780588635	96 Count	850 Count
1780587734	95 Count	839 Count
1780586833	94 Count	829 Count
1780585933	93 Count	822 Count
1780585032	92 Count	814 Count
1780584132	91 Count	806 Count
1780583232	90 Count	801 Count
1780582330	89 Count	796 Count
1780581443	84 Count	788 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)