APRS Track Direct

My position About ☰

reset

SP6PAK-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP6PAK-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1775212652	157 Count	745 Count	145 Count
1775210851	152 Count	677 Count	141 Count
1775209051	147 Count	642 Count	137 Count
1775207257	136 Count	597 Count	127 Count
1775205457	119 Count	525 Count	111 Count
1775203656	108 Count	493 Count	101 Count
1775201855	95 Count	439 Count	89 Count
1775200055	90 Count	366 Count	85 Count
1775198254	83 Count	298 Count	79 Count
1775196453	78 Count	245 Count	75 Count
1775194653	48 Count	149 Count	46 Count
1775192852	8 Count	58 Count	7 Count
1775191052	3 Count	28 Count	3 Count
1775189251	176 Count	1005 Count	154 Count
1775187450	167 Count	971 Count	146 Count
1775185657	163 Count	942 Count	143 Count
1775183856	158 Count	911 Count	139 Count
1775182055	154 Count	882 Count	136 Count
1775180255	149 Count	852 Count	132 Count
1775178454	145 Count	824 Count	129 Count
1775176653	140 Count	795 Count	125 Count
1775174853	137 Count	770 Count	123 Count
1775173052	133 Count	740 Count	120 Count
1775169451	124 Count	685 Count	113 Count
1775167650	120 Count	655 Count	110 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)