APRS Track Direct

My position About ☰

reset

SM0PQB-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SM0PQB-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1769628502	100 Count	853 Count
1769626699	99 Count	846 Count
1769624896	98 Count	837 Count
1769623093	97 Count	824 Count
1769621290	96 Count	813 Count
1769619487	95 Count	803 Count
1769615914	89 Count	782 Count
1769614111	88 Count	770 Count
1769612308	87 Count	759 Count
1769608702	85 Count	746 Count
1769606899	84 Count	734 Count
1769605096	83 Count	722 Count
1769603294	82 Count	711 Count
1769601490	81 Count	699 Count
1769599687	80 Count	687 Count
1769596985	74 Count	680 Count
1769591576	71 Count	653 Count
1769589773	70 Count	641 Count
1769587970	69 Count	630 Count
1769582114	64 Count	630 Count
1769580311	63 Count	619 Count
1769578507	62 Count	607 Count
1769576704	61 Count	596 Count
1769574901	60 Count	583 Count
1769573099	59 Count	573 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)