APRS Track Direct

My position About ☰

reset

SV1SSF-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SV1SSF-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1785846411	52 Count	114 Count	47 Count
1785844605	44 Count	99 Count	40 Count
1785842799	34 Count	81 Count	31 Count
1785840994	26 Count	61 Count	24 Count
1785839188	15 Count	42 Count	14 Count
1785837383	7 Count	18 Count	7 Count
1785835577	477 Count	1008 Count	425 Count
1785833772	466 Count	982 Count	415 Count
1785831966	457 Count	958 Count	407 Count
1785830161	447 Count	932 Count	398 Count
1785828354	438 Count	911 Count	390 Count
1785826549	430 Count	893 Count	383 Count
1785824743	422 Count	876 Count	376 Count
1785822938	412 Count	857 Count	367 Count
1785821132	406 Count	844 Count	362 Count
1785819736	399 Count	836 Count	356 Count
1785817930	391 Count	821 Count	349 Count
1785816124	381 Count	806 Count	340 Count
1785814319	373 Count	789 Count	333 Count
1785812513	364 Count	770 Count	325 Count
1785810708	356 Count	756 Count	318 Count
1785808902	344 Count	739 Count	307 Count
1785807097	334 Count	716 Count	298 Count
1785805291	328 Count	703 Count	293 Count
1785803486	318 Count	686 Count	284 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)