APRS Track Direct

My position About ☰

reset

F4IZM-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F4IZM-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1785825807	142 Count	405 Count	115 Count
1785824002	134 Count	386 Count	108 Count
1785822197	128 Count	370 Count	103 Count
1785820392	123 Count	355 Count	99 Count
1785818587	119 Count	343 Count	96 Count
1785816782	114 Count	330 Count	92 Count
1785814977	109 Count	314 Count	88 Count
1785813172	104 Count	298 Count	84 Count
1785811367	100 Count	280 Count	81 Count
1785809562	95 Count	263 Count	77 Count
1785807757	90 Count	246 Count	73 Count
1785805952	85 Count	230 Count	69 Count
1785804146	80 Count	214 Count	65 Count
1785802341	75 Count	200 Count	61 Count
1785800537	70 Count	184 Count	57 Count
1785798732	65 Count	171 Count	53 Count
1785796927	61 Count	161 Count	50 Count
1785795122	56 Count	146 Count	46 Count
1785793317	51 Count	131 Count	42 Count
1785791512	46 Count	115 Count	38 Count
1785789707	41 Count	100 Count	34 Count
1785787902	36 Count	84 Count	30 Count
1785786097	30 Count	65 Count	25 Count
1785784292	24 Count	44 Count	20 Count
1785782487	19 Count	34 Count	16 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)