APRS Track Direct

My position About ☰

reset

SQ8RZE-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ8RZE-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1765751920	297 Count	532 Count	224 Count
1765751013	292 Count	521 Count	220 Count
1765750109	288 Count	510 Count	217 Count
1765749205	284 Count	502 Count	214 Count
1765748298	279 Count	493 Count	210 Count
1765747394	275 Count	482 Count	207 Count
1765746490	271 Count	474 Count	204 Count
1765745584	266 Count	464 Count	200 Count
1765744677	261 Count	456 Count	196 Count
1765743770	256 Count	448 Count	192 Count
1765742866	252 Count	437 Count	189 Count
1765741962	248 Count	429 Count	186 Count
1765741056	243 Count	422 Count	182 Count
1765740150	238 Count	416 Count	178 Count
1765739245	234 Count	409 Count	175 Count
1765738337	228 Count	400 Count	170 Count
1765737430	223 Count	392 Count	166 Count
1765736524	218 Count	383 Count	162 Count
1765735620	214 Count	376 Count	159 Count
1765734713	209 Count	367 Count	155 Count
1765733807	204 Count	357 Count	151 Count
1765732121	190 Count	340 Count	143 Count
1765731214	185 Count	331 Count	139 Count
1765730308	180 Count	321 Count	135 Count
1765729400	174 Count	310 Count	130 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)