APRS Track Direct

My position About ☰

reset

SR9EMP-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR9EMP-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1791106250	22 Count	1038 Count
1791102647	11 Count	745 Count
1791100846	7 Count	555 Count
1791099046	3 Count	307 Count
1791095468	13 Count	780 Count
1791093668	8 Count	487 Count
1791091867	3 Count	226 Count
1791090066	19 Count	1236 Count
1791088265	11 Count	870 Count
1791086465	4 Count	424 Count
1791084664	18 Count	1066 Count
1791082863	16 Count	871 Count
1791081044	13 Count	658 Count
1791079243	8 Count	409 Count
1791077442	3 Count	196 Count
1791075710	22 Count	1002 Count
1791073909	16 Count	793 Count
1791072109	13 Count	642 Count
1791070298	10 Count	446 Count
1791068497	7 Count	255 Count
1791066697	1 Count	161 Count
1791064886	16 Count	1148 Count
1791063074	13 Count	895 Count
1791061274	9 Count	641 Count
1791059473	5 Count	461 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)