APRS Track Direct

My position About ☰

reset

SP9APJ-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP9APJ-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1775224430	118 Count	785 Count	96 Count
1775222629	113 Count	748 Count	92 Count
1775220828	107 Count	709 Count	87 Count
1775219028	101 Count	663 Count	82 Count
1775217227	93 Count	633 Count	75 Count
1775215426	87 Count	590 Count	70 Count
1775213626	82 Count	554 Count	66 Count
1775211825	77 Count	509 Count	62 Count
1775210025	72 Count	468 Count	58 Count
1775208230	63 Count	433 Count	54 Count
1775204629	52 Count	367 Count	45 Count
1775201028	41 Count	297 Count	36 Count
1775199227	35 Count	256 Count	31 Count
1775195626	20 Count	160 Count	18 Count
1775193825	13 Count	118 Count	12 Count
1775192025	4 Count	58 Count	4 Count
1775190224	101 Count	1042 Count	77 Count
1775188424	95 Count	983 Count	72 Count
1775186629	85 Count	922 Count	67 Count
1775184829	78 Count	850 Count	61 Count
1775183028	71 Count	789 Count	55 Count
1775181228	65 Count	716 Count	50 Count
1775179427	60 Count	652 Count	46 Count
1775177626	53 Count	598 Count	40 Count
1775175826	46 Count	531 Count	34 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)