APRS Track Direct

My position About ☰

reset

SP8NCG-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP8NCG-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1791082252	969 Count	938 Count
1791080451	962 Count	935 Count
1791078650	957 Count	932 Count
1791076850	953 Count	929 Count
1791075049	950 Count	926 Count
1791073248	946 Count	923 Count
1791071447	945 Count	920 Count
1791067855	933 Count	914 Count
1791066055	926 Count	911 Count
1791064254	921 Count	908 Count
1791062453	914 Count	905 Count
1791060652	909 Count	902 Count
1791058851	902 Count	899 Count
1791057051	897 Count	896 Count
1791055250	890 Count	893 Count
1791053449	885 Count	890 Count
1791051648	881 Count	887 Count
1791049847	880 Count	884 Count
1791048055	873 Count	881 Count
1791046254	868 Count	878 Count
1791044453	861 Count	875 Count
1791042652	856 Count	872 Count
1791040851	849 Count	869 Count
1791039051	844 Count	866 Count
1791037250	837 Count	863 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)