APRS Track Direct

My position About ☰

reset

SQ2WSZ-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ2WSZ-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1791110700	43 Count	186 Count	37 Count
1791110099	34 Count	131 Count	29 Count
1791109498	21 Count	66 Count	17 Count
1791108923	398 Count	1016 Count	317 Count
1791108322	388 Count	976 Count	308 Count
1791107722	384 Count	966 Count	305 Count
1791107121	379 Count	949 Count	301 Count
1791106520	375 Count	937 Count	298 Count
1791105920	370 Count	924 Count	294 Count
1791105319	362 Count	897 Count	287 Count
1791104718	356 Count	879 Count	282 Count
1791104117	350 Count	867 Count	277 Count
1791103517	345 Count	851 Count	273 Count
1791102916	339 Count	838 Count	268 Count
1791102315	335 Count	829 Count	265 Count
1791101714	331 Count	817 Count	262 Count
1791101114	324 Count	801 Count	256 Count
1791100513	320 Count	791 Count	253 Count
1791099912	315 Count	771 Count	249 Count
1791099311	305 Count	750 Count	240 Count
1791098711	290 Count	719 Count	226 Count
1791098110	273 Count	689 Count	210 Count
1791096908	263 Count	663 Count	202 Count
1791096307	258 Count	651 Count	198 Count
1791095105	249 Count	626 Count	191 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)