APRS Track Direct

My position About ☰

reset

SR2BC-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR2BC-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1785876019	104 Count	611 Count	30 Count
1785874218	102 Count	601 Count	29 Count
1785872417	100 Count	589 Count	28 Count
1785870616	98 Count	575 Count	27 Count
1785868815	96 Count	559 Count	26 Count
1785867014	93 Count	532 Count	24 Count
1785865213	91 Count	502 Count	23 Count
1785861611	85 Count	447 Count	19 Count
1785859810	82 Count	412 Count	17 Count
1785858015	80 Count	382 Count	16 Count
1785856214	78 Count	356 Count	15 Count
1785854413	76 Count	343 Count	14 Count
1785852612	72 Count	332 Count	12 Count
1785850811	67 Count	324 Count	11 Count
1785849010	62 Count	314 Count	10 Count
1785847209	58 Count	308 Count	9 Count
1785845408	54 Count	302 Count	8 Count
1785843608	49 Count	293 Count	6 Count
1785841807	41 Count	271 Count	5 Count
1785840006	33 Count	197 Count	4 Count
1785838205	26 Count	124 Count	3 Count
1785836414	23 Count	58 Count	2 Count
1785834613	170 Count	1038 Count	62 Count
1785832812	159 Count	979 Count	61 Count
1785831011	143 Count	919 Count	60 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)